SI2 Micro Integration Line, Power Amplifier
Front Panel
- POWER ON LED : Power is ON when this LED is illuminating in red. The Power Amplifier is turned ON when AC adapter is connected, and it is designed to be ON at all times. Unplug AC adaptor from AC outlet when the Power Amplifier is not in use for a prolonged time.
- MUTE ON-OFF Switch : When this switch is “ON” , the output of the Power Amplifier is muted. Switch position “ON” means signal muted, position “OFF” means signal is non-muted.
- INPUT L/R : Audio input terminals. Output signals from devices such as pre amplifiers can be connected.
- OUTPUT : Speaker terminals. Since the Power Amplifier is internally BTL configured, bridged connection by using the plus (red) terminals of L-channel and R-channel can not be accomplished. Since minus (black) terminal is not connected to the ground level of the chassis, please do not make connection to earth grounding. Please make proper connections to speaker systems using plus (red) and minus (black) terminals.
- DC INPUT : Connector for AC adaptor plug. Do not use AC adaptors other than what comes supplied with the Power Amplifier.
- Please refer to the instructions for such optional power supplies when using them.
| Inputs | Single Ended (RCA) / 30Kohm |
|---|---|
| Outputs | 1 Pair Speaker Terminals (Banana) |
| Output Power | 14W/RL= 4ohm, f=20Hz~20KHz, THD=1% |
| Gain | 32dB / Vout = 0.775Vrms (0dBm) |
| THD | 0.02% / Pout=4W |
| Phase | Polarity Non Inverting |
| Power Requirements | 12V DC / 3 to 6A (Center +) |
| Dimensions | 106mm(W) x 45.6mm(H) x 110mm(D) |
| Net Weight | 600g |
