SI2 Micro Integration Line, DAC

Front Panel

POWER ON LED : Power is ON when this LED is illuminating in red. The DAC is designed to be ON at all times. Unplug AC adaptor from AC outlet when the DAC is not in use for a prolonged time.
UNLOCK LED : Incoming digital signal is not properly handled when this LED is illuminating in yellow. Please go through set up procedure again by following the operation instructions. When incoming digital signal is properly handled, LED should not be illuminating.

Rear Panel

DIGITAL INPUT : S/PDIF digital input terminal. Digital output signals from CD players and transports can be used.
OUTPUT : Audio output terminals. The output is connected to devices such as pre ampli ers. Since I/V converted signal comes directly out to these terminals, high capacitance and long cables can not be used. Use low capacitance and short cables for connection to preamps (0.5M recommended).
DC INPUT : Connector for AC adaptor plug. Do not use AC adaptors other than what comes supplied with the DAC.
Please refer to the instructions for such optional power supplies when using them.

Inputs	1 Digital Input (S/PDIF), Single Ended (RCA)
Outputs	1 Stereo Pair, Single Ended (RCA)
Phase	Polarity Inverting
Power Requirements	12V DC / 300mA (Center +)
Dimensions	106mm(W) x 45.6mm(H) x 105mm(D)
Net Weight	500g